Geothermal Heat Pump Retrofit Installation

What follows is an example of a 3-ton system with (2) 220-foot vertical loops, which took the driller two days to install.

1. The 6” wide by 220’ deep bore holes were drilled, and the poly loop was installed
2. ​​The trench was dug, and the loop was connected through the foundation to the Flowcenter.
3. The propane furnace was replaced with a Heat Pump, the plumbing between the Flowcenter and the Heat Pump was installed, and the overall system tested.

Find out more:

CLICK HERE

1. Location of bore-holes at the front of the property

2. Drilling equipment needed to install the system

3. A trench is dug to connect outside loop to Flow Center

4. Outside loop through the foundation

5. Inside sealed

6. Flow Center installed

7. Heat pump installed

BACK TO CLEAN HEATING & COOLING